hydraulic gate cylinder Sold to Australia

This article mainly introduces:

Australia hydraulic cylinder,hydraulic gate cylinder manufacturer,hydraulic gate cylinder

(Australia hydraulic gate cylinder,produced by Hengyu Hydraulic Cylinder Factory）

hydraulic gate cylinder are widely used in Australia，because of no transmission clearance，simple structure and reliable operation，excellent temperature resistance.So our company has designed hydraulic gate cylinder for customers from Australia.

Introduction to hydraulic gate cylinder:

The commonly used buffer structure of the hydraulic gate cylinder is composed of a piston boss and a hydraulic gate cylinder head groove. When the piston moves close to the hydraulic gate cylinder head, it gradually enters the groove, and the oil in the groove is extruded through the gap between the boss and the groove, which increases the oil return resistance, produces the braking effect and realizes the buffer. Generally, a buffer mechanism should be used when the pressure is above 10MP.

At the rated pressure, the thrust of the hydraulic gate cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the hydraulic gate cylinder is related to the diameter of the hydraulic gate cylinder, but not to the stroke of the hydraulic gate cylinder. Moreover, the larger the hydraulic gate cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the hydraulic gate cylinder.

The material of the sliding part of the hydraulic gate cylinder piston sintered casting piston will cause sintering phenomenon when subjected to large transverse load. In this case, the sliding part of the piston should be made of copper alloy or welded to such material.

hydraulic gate cylinder piston rod material introduction: In general, we use 45 steel to produce hydraulic gate cylinder piston rod. It has a large impact force when it is used, and some good performance steel are also used in the heavy load transmission. In order to have enough work intensity when using, and can ensure normal use, this is still more critical to have a detailed understanding of the material.

Answers to some questions about hydraulic gate cylinder:

Why does the hydraulic cylinder ring?
1 Air intrusion into the hydraulic system is the main reason for noise 2 The relief valve is unstable, such as due to the improper combination of the slide valve and the valve hole or the contact of the cone valve and the seat is stuck by dirt, the damping hole is blocked, the spring is crooked or fails to make the spool stuck or move in the valve hole, causing system pressure fluctuation and noise. 3 Improper adjustment of the reversing valve causes the spool of the reversing valve to move too fast, resulting in reversing impact, resulting in noise and vibration. 4 Mechanical vibration, such as long tubing, elbow more and not fixed, when the oil flow through, especially when the flow rate is high, easy to cause pipe shaking; The rotating part of the motor and hydraulic pump is unbalanced, or the alignment is not good during installation, or the coupling is loose, etc., which can produce vibration and noise.

What are the connection methods of the hydraulic cylinder? The connection modes of the cylinder and the actuator are earring connection, hinge shaft connection, thread connection, etc. The connection modes of tubing and cylinder are threaded connection, flange connection, etc.