reciprocating cylinder Sold to Sri Lanka

This article mainly introduces:

Sri Lanka hydraulic cylinder,reciprocating cylinder manufacturer,reciprocating cylinder

(Sri Lanka reciprocating cylinder,produced by Hengyu Hydraulic Co., Ltd）

reciprocating cylinder are widely used in Sri Lanka，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed reciprocating cylinder for customers from Sri Lanka.

Introduction to reciprocating cylinder:

In recent years, the processing process of the reciprocating cylinder generally adopts the rolling method, which is a pressure finishing processing, which uses the cold plastic characteristics of the metal at room temperature, and uses the rolling tool to exert a certain pressure on the surface of the workpiece, so that the surface metal of the workpiece produces plastic flow, and fills in the low concave trough of the original residue, and the roughness value of the workpiece surface is reduced. Due to the plastic deformation of the rolled surface metal, the surface tissue is cold hardened and the grain is fine, forming a dense fiber, and forming a residual stress layer, and the hardness and strength are increased, thus improving the wear resistance, corrosion resistance and compatibility of the workpiece surface. Rolling is a plastic machining method without cutting.

Regular maintenance of the reciprocating cylinder includes: regular tightening, reciprocating cylinder fastening screws and gland screws, reciprocating cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the reciprocating cylinder once a year. Clean regularly, the reciprocating cylinder is cleaned every other year, and the seals are replaced while cleaning.

If the piston rod and reciprocating cylinder are stuck or the reciprocating cylinder is blocked, at this time, no matter how to operate, the reciprocating cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the reciprocating cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.

1, the hydraulic machinery should be kept clean, in order to prevent dust and debris from falling into the oil, the tank should be sealed. 2, the oil in the tank should be replaced regularly according to the working condition. When changing the oil, the dirt and impurities accumulated at the bottom of the tank should be removed and the tank should be cleaned. 3, hydraulic oil, oil drums should be set in a clean and safe place to strengthen management. The oil drum, oil filter, oil funnel, oil pipe, etc. used should be kept clean. The oil drums for loading hydraulic oil must be cleaned in advance, and the oil drums should be dedicated and not mixed with other oil drums.

Answers to some questions about reciprocating cylinder:

How to calculate hydraulic cylinder flow?
Effective area of the cylinder x stroke = volume usually in liters. Volume/estimated total travel time (converted to minutes) = oil flow rate.

How to change the seal ring of lift oil cylinder of forklift truck?
Remove the cylinder, put it on the vise, first screw off the big nut plug on the head, and then pull out the guide sleeve, you can directly pull out the core of the cylinder, if it is to change the seal of the cylinder head, the core does not need to be pulled out, if it is to change the seal inside, pull it out and see the oil seal, remove it and replace it, there are three seals of the cylinder head, the inner seal, The outer seal, dustproof, it is best to replace them all together, and be sure to keep them clean when changing, and you can lubricate them with clean hydraulic oil.