spring return cylinder Sold to America

This article mainly introduces:

America hydraulic cylinder,spring return cylinder manufacturer,spring return cylinder

(America spring return cylinder,produced by Hengyu Group）

spring return cylinder are widely used in America，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed spring return cylinder for customers from America.

Introduction to spring return cylinder:

Under normal circumstances, the spring return cylinder is composed of the rear end cover, body, piston, piston rod and front end cover and other main parts. In order to prevent the working medium from leaking out of the spring return cylinder or from the high pressure chamber to the low pressure chamber, a sealing device (sealing ring) is arranged between the spring return cylinder and the end cover, the piston and the piston rod, the piston and the spring return cylinder, the piston rod and the front end cover. A dustproof device is also provided on the outside of the front end cover. In order to prevent the piston from impacting the end cap when it moves rapidly to the end of the stroke, the end of the spring return cylinder can also be provided with a buffer device. If necessary, the exhaust device should be set in order to exhaust.

The material of the sliding part of the spring return cylinder piston sintered casting piston will cause sintering phenomenon when subjected to large transverse load. In this case, the sliding part of the piston should be made of copper alloy or welded to such material.

spring return cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the spring return cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the spring return cylinder. c. The spring return cylinder seal is extruded, if the O-ring is obviously extruded at the spring return cylinder seal, replace the spring return cylinder seal.

In the process of using the spring return cylinder, sometimes such a problem will occur, the spring return cylinder can not act immediately after the instruction of the spring return cylinder action is issued, and it must be moved after a short time, or sometimes it can move and stop moving, showing that the operation is very irregular. The cause and elimination of this failure mainly include air in the oil spring return cylinder. Elimination method: exhaust through the exhaust valve. Check the piston rod reciprocating parts of the sealing ring for air inhalation, if so, replace the sealing ring.

Answers to some questions about spring return cylinder:

What hydraulic oil does servo cylinder generally use?
The medium used by the cylinder generally depends on the working condition of the use, including pressure, installation environment, sealing material, etc. I think the first thing to consider is the impact of the sealing material. Mineral oil is a good choice if it is not too fire-resistant or used in a high temperature environment. 1, servo cylinder features: closed-loop servo control, control accuracy of 0.01mm; Precise control of thrust, increase pressure sensor, control accuracy up to 1%; It is easy to connect with PLC and other control systems to achieve high precision motion control. Low noise, energy saving, clean, high rigidity, impact resistance, long life, simple operation and maintenance. 2, the servo cylinder can be fault-free in harsh environments, and the protection level can reach IP66.

Can pneumatic cylinder be used as hydraulic cylinder?
The pneumatic cylinder can only be used for pressure below 1MPA, and if it is used for hydraulic, the pressure should be under 1MPA, which may not meet the strength requirements. And the seals should use fluorine rubber to avoid corrosion. But pneumatic cylinder used as hydraulic cylinder is not whimsical, in fact, there is such a use. The pneumatic system has a natural defect, that is, the speed is unstable, especially in the case of low speed. The hydraulic pressure is very stable, if you do not want to buy a set of hydraulic system, while the strength of the cylinder is not large, you can use compressed air to push the hydraulic oil, with hydraulic oil to drive the cylinder, The force is the same as compressed air, but very smooth.