400 tons hydrauli ccylinder Sold to Bangladesh

This article mainly introduces:

Bangladesh hydraulic cylinder,400 tons hydrauli ccylinder manufacturer,400 tons hydrauli ccylinder

(Bangladesh 400 tons hydrauli ccylinder,produced by Hengyu Hydraulic Co., Ltd）

400 tons hydrauli ccylinder are widely used in Bangladesh，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed 400 tons hydrauli ccylinder for customers from Bangladesh.

Introduction to 400 tons hydrauli ccylinder:

The quality of the 400 tons hydrauli ccylinder can not be ignored in the purchase of the 400 tons hydrauli ccylinder. The 400 tons hydrauli ccylinder is the main component of the 400 tons hydrauli ccylinder, the single pillar for mining, the hydraulic support, the gun tube and other products, and its processing quality directly affects the life and reliability of the entire product. 400 tons hydrauli ccylinder processing requirements are high, its internal surface roughness requirements are Ra0.4 ~ 0.8μm, the coaxiality, wear resistance requirements are strict. The basic feature of 400 tons hydrauli ccylinder is deep hole processing, which has always troubled the processing personnel.

The body of the 400 tons hydrauli ccylinder on the processing process requirements: the body of the 400 tons hydrauli ccylinder is an important and essential part of the 400 tons hydrauli ccylinder, because it has an irreplaceable role. The processing requirements for this part are very high, requiring that the surface roughness of the 400 tons hydrauli ccylinder after processing should reach 0.4-0.8um, and the coaxiality and wear resistance requirements are also very high.

When the 400 tons hydrauli ccylinder is installed, it is necessary to ensure that the direction of the connecting head at the top of the piston rod should be consistent with the direction of the 400 tons hydrauli ccylinder head, earring (or middle hinge shaft), and ensure the straightness of the whole piston rod during the advance and return process to prevent rigid interference and cause unnecessary damage.

The 400 tons hydrauli ccylinder pipe should not be left behind when deburring at both ends after the fixed length processing. In addition, the placement of steel pipes near the site of welding pipeline operations is the cause of welding foreign objects. The pipes placed near the welding operation site should be sealed. It must also be noted that pipe fitting materials should be fully prepared on a dust-free workbench.

Answers to some questions about 400 tons hydrauli ccylinder:

Can multiple identical hydraulic cylinders be supplied with the same supply line?
This can be connected, but there is a disadvantage, that is, the hydraulic cylinder with the minimum pressure is extended first, and then the pressure is higher, and then the higher, until all the hydraulic cylinders are extended, which may not meet the requirements of field use.

Is there a way to make the cylinder stop pushing when it hits something hard during the process of pushing?
The simplest solution is to press the stop switch, this switch has a mechanical type, touch the object on the action or send a stop signal, through the operation of the motor control cylinder; There is also an induction switch, that is, when the hydraulic cylinder expands to the range of the induction switch can sense the signal, it sends a signal to let the motor act, resulting in the corresponding action of the cylinder.