loading cylinder Sold to Pakistan

This article mainly introduces:

Pakistan hydraulic cylinder,loading cylinder manufacturer,loading cylinder

(Pakistan loading cylinder,produced by Hengyu Hydraulic Co., Ltd）

loading cylinder are widely used in Pakistan，because of excellent temperature resistance，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed loading cylinder for customers from Pakistan.

Introduction to loading cylinder:

When installing the loading cylinder pipe, the pipe should be cleaned after installation, and should not pass through the loading cylinder block, and the by-pass pipe must be installed in front of the oil port of the loading cylinder block. This is important. Otherwise, the foreign body in the pipeline will enter the loading cylinder, and once it enters, it is difficult to exclude it, but it becomes a foreign body transported to the loading cylinder. Moreover, when cleaning, the removal method of foreign bodies entered in the installation pipeline operation should be considered. In addition, the corrosion in the pipe should be pickling and other procedures before the pipe installation, and the rust must be completely removed.

When the loading cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the loading cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil loading cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical loading cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the loading cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

Protection of the loading cylinder surface: During the dismantling process, safety protection should be carried out on the loading cylinder to prevent objects from falling and welding slag from falling to the surface, causing damage to the loading cylinder surface. In the process of propulsion, the damaged pipe segments should be prevented from falling and smashing, and the slurry remaining on the surface of the loading cylinder should be cleaned up in time.

The quality of the loading cylinder can not be ignored in the purchase of the loading cylinder. The loading cylinder is the main component of the loading cylinder, the single pillar for mining, the hydraulic support, the gun tube and other products, and its processing quality directly affects the life and reliability of the entire product. loading cylinder processing requirements are high, its internal surface roughness requirements are Ra0.4 ~ 0.8μm, the coaxiality, wear resistance requirements are strict. The basic feature of loading cylinder is deep hole processing, which has always troubled the processing personnel.

Answers to some questions about loading cylinder:

The cylinder is moving too fast. I want to slow it down. What can I do?
The hydraulic cylinder is the execution action, and the power source is the hydraulic system. The cylinder speed is too fast, indicating that the system flow is large, the hydraulic system has a hydraulic valve responsible for speed control function, method: 1, by adjusting the speed control valve to reduce the speed; 2, the speed control valve has been adjusted to the lowest, indicating that the hydraulic system design flow is too high, the need to re-configure the hydraulic system according to demand, or the cylinder diameter is changed.

Can one hydraulic pump with two cylinders work?
A hydraulic pump with two cylinders will work. Commonly used hydraulic pump types: 1, according to whether the flow can be adjusted can be divided into: variable pump and quantitative pump. The output flow can be adjusted according to the needs of the variable pump, the flow can not be adjusted called quantitative pump. 2, according to the pump structure commonly used in the hydraulic system is divided into: gear pump, vane pump and plunger pump 3 kinds. Gear pump: small volume, simple structure, the cleanliness of the oil requirements are not strict, the price is cheaper; However, the pump shaft is subjected to unbalanced force, serious wear and leakage. Vane pump: divided into double acting vane pump and single acting vane pump. The pump has uniform flow, smooth operation, low noise, higher pressure and volumetric efficiency than gear pump, and more complex structure than gear pump.