stacker cylinder Sold to Bangladesh

This article mainly introduces:

Bangladesh hydraulic cylinder,stacker cylinder manufacturer,stacker cylinder

(Bangladesh stacker cylinder,produced by Hengyu Group）

stacker cylinder are widely used in Bangladesh，because of powerful torque，clever hydraulic energy conversion，simple structure and reliable operation.So our company has designed stacker cylinder for customers from Bangladesh.

Introduction to stacker cylinder:

The piston seal of the stacker cylinder is the main element to prevent leakage in the stacker cylinder. For the lip seal, it should focus on checking whether the lip edge is bruised and worn, and for the combination seal, it should focus on checking the wear of the sealing surface, and then determine whether the seal can be used. In addition, it is necessary to check whether the static seal between the piston and the piston rod is crushed. The piston rod seal should focus on checking the wear of the seals and supporting rings.

The internal leakage of the stacker cylinder is an important indicator to measure the quality of the stacker cylinder: the internal leakage of the stacker cylinder will reduce the volumetric efficiency, increase the temperature rise of the oil, affect the positioning accuracy of the stacker cylinder, so that the stacker cylinder can not accurately and stably stop in a certain position of the stacker cylinder, so it is one of the main indicators of the stacker cylinder.

The internal leakage of the stacker cylinder should be prevented when the stacker cylinder is used. The internal leakage of stacker cylinder includes the leakage caused by excessive wear of stacker cylinder block seal, piston rod and seal cover seal and piston seal. The cause of sealing leakage between the piston rod and the seal cover is that the seal is wrinkled, squeezed, torn, worn, aging, deterioration, deformation, etc., and a new seal should be replaced at this time.

The material of the sliding part of the stacker cylinder piston sintered casting piston will cause sintering phenomenon when subjected to large transverse load. In this case, the sliding part of the piston should be made of copper alloy or welded to such material.

Answers to some questions about stacker cylinder:

For a cylinder with a piston diameter of 100mm and a system pressure of 10MPa, what is the thrust?
Thrust is 7850 kg. Piston area A= πR^2=7850 square mm =78.5 square cm 10MPa = 100kg/cm^2 "^2" is square F = A x P =78.5 x 100=7850 kg.

Slide weight 35 kg exit stroke 55mm, is it suitable to use 40 cylinder diameter cylinder?
The maximum output force of the 40-bore hydraulic cylinder can reach 2 tons, and whether it can be used depends on the use scenario. In addition, the problem of mechanism stuck has nothing to do with the size of the power source, and reasonable structural design and good machining and assembly accuracy are the key.