swager cylinder Sold to Thailand

This article mainly introduces:

Thailand hydraulic cylinder,swager cylinder manufacturer,swager cylinder

(Thailand swager cylinder,produced by Hengyu Hydraulic Co., Ltd）

swager cylinder are widely used in Thailand，because of no need for deceleration device，long service life，smooth movement.So our company has designed swager cylinder for customers from Thailand.

Introduction to swager cylinder:

swager cylinder and hydraulic station selection: Select the type and structure of the swager cylinder according to the operation requirements of the main engine. According to the external load force borne by the swager cylinder, such as gravity, friction force of the external mechanism, inertia force and working load, determine the load change law of the swager cylinder in each stage of the stroke and the power value that must be provided. Determine the diameter of the piston and piston rod according to the working load of the swager cylinder and the selected oil working pressure. the flow rate of the hydraulic pump is determined according to the movement speed of the swager cylinder, the diameter of the piston and the piston rod.

swager cylinder buffer valve inspection and maintenance: For the valve buffer swager cylinder, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

When the swager cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the swager cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

If the seal of the swager cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.

Answers to some questions about swager cylinder:

How to control the speed of the hydraulic cylinder?
The speed of the hydraulic cylinder is only related to the flow, so the control speed is to control the flow of the hydraulic oil, which is generally adjusted by the throttle valve in the system.

Do the collecting cylinder, distributing cylinder and distributing cylinder on the organic heat carrier boiler need to be notified separately as the pressure vessel for construction?
Do not need to be installed as a separate pressure vessel to inform, according to the organic heat carrier boiler can be informed. Write a "special equipment installation, renovation and maintenance notice" issued on it.