shearing machine cylinder Sold to Morocco

This article mainly introduces:

Morocco hydraulic cylinder,shearing machine cylinder manufacturer,shearing machine cylinder

(Morocco shearing machine cylinder,produced by Hengyu Hydraulic Co., Ltd）

shearing machine cylinder are widely used in Morocco，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed shearing machine cylinder for customers from Morocco.

Introduction to shearing machine cylinder:

At the rated pressure, the thrust of the shearing machine cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the shearing machine cylinder is related to the diameter of the shearing machine cylinder, but not to the stroke of the shearing machine cylinder. Moreover, the larger the shearing machine cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the shearing machine cylinder.

How the cavitation of the shearing machine cylinder is formed: With the gradual rise of pressure, the gas in the oil will become bubbles, when the pressure rises to a certain limit value, these bubbles will break under the action of high pressure, so that the high temperature and high pressure gas will quickly act on the surface of the parts, resulting in cavitation of the shearing machine cylinder, resulting in corrosive damage to the parts.

In the case of serious wear on the inner surface of the shearing machine cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the shearing machine cylinder manufacturing process for replacement. The shearing machine cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

Improve the service life of the shearing machine cylinder: it is necessary to maintain the normal clearance of the combined surface of the hydraulic components. When manufacturing or repairing the main parts of the shearing machine cylinder (such as the shearing machine cylinder block, piston rod, etc.), the assembly should be carried out in accordance with the tolerance lower limit of the assembly size, which can well reduce the occurrence of cavitation. If cavitation has occurred in the hydraulic components, only metallographic sandpaper polishing technology can be used to remove cavitation pitting and surface carbon deposits, and general fine sandpaper must not be used for polishing After the shearing machine cylinder is repaired, the hydraulic system should run smoothly for a certain period of time so that the hydraulic oil in the hydraulic system can be fully circulated; If necessary, the shearing machine cylinder inlet pipe (or return pipe) can be disassembled. Make the hydraulic oil overflow to achieve the effect of single shearing machine cylinder exhaust.

Answers to some questions about shearing machine cylinder:

Loader arm fell badly, how to know which oil cylinder is leaking?
No matter which cylinder leakage the arm will drop, it is best to replace the oil seal, even if one cylinder is good, it will not last long, and it will drop the arm, so the two cylinders should be replaced at once.

How to use a solenoid valve to control the expansion of a cylinder? Doesn't the solenoid valve only control on/off?
Use the solenoid valve P into A-B (generally equipped with oil circuit board) to connect the oil inlet interface at both ends of the cylinder, and the solenoid valve can be realized by power off (refer to the solenoid valve 2B2L, different solenoid valve actions are different).