steering power cylinder Sold to Kazakhstan

This article mainly introduces:

Kazakhstan hydraulic cylinder,steering power cylinder manufacturer,steering power cylinder

(Kazakhstan steering power cylinder,produced by Hebei Hengyu company）

steering power cylinder are widely used in Kazakhstan，because of no transmission clearance，powerful torque，clever hydraulic energy conversion.So our company has designed steering power cylinder for customers from Kazakhstan.

Introduction to steering power cylinder:

In order to ensure the service life of the steering power cylinder, the hydraulic system must be set up effective filtration to prevent pollution, the cleanliness of the oil should meet the ISO4406 standard, and the quality of the filtration should also meet the corresponding standards in ISO. The grade requirements of the filter are performed according to the actual working conditions of the system, but the minimum requirements are not less than 19/15 in ISO4406, that is, 24μ (β10≥75) in ISO4572.

The steering power cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the steering power cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the steering power cylinder wall due to the stiffness and the weight of the parts, causing scars.

steering power cylinder use should try to avoid sealing belt into the steering power cylinder. As a simple sealing material, polytetrafluoroethylene plastic sealing tape is often used in installation and inspection, and if the winding method of the linear and ribbon-shaped sealing material is wrong, the sealing tape will be cut off and enter the steering power cylinder. The wire belt seal will not have any effect on the winding of the sliding part, but it will cause the check valve of the steering power cylinder to fail to operate or the buffer regulating valve can not be adjusted to the end. For the circuit, it may cause the action of the reversing valve, the relief valve and the reducing valve to fail.

When the steering power cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

Answers to some questions about steering power cylinder:

How to calculate the cross-sectional area of hydraulic cylinder?
Hydraulic cylinder cross section integral rod cavity and rodless cavity: rod cavity is cylinder inner wall cross-sectional area - piston rod cross-sectional area; The rodless cavity is the cross-sectional area of the inner wall of the cylinder. If the working pressure p and the output force F are known, the effective cross-sectional area A=F/p can be calculated.

The hydraulic cylinder is slow when moving forward and faster when moving back.
If the cylinder is single, it is slow when it is moving forward without the rod cavity, and fast when it is shrinking.