servo hydraulic cylinder Sold to Kazakhstan

This article mainly introduces:

Kazakhstan hydraulic cylinder,servo hydraulic cylinder manufacturer,servo hydraulic cylinder

(Kazakhstan servo hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

servo hydraulic cylinder are widely used in Kazakhstan，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed servo hydraulic cylinder for customers from Kazakhstan.

Introduction to servo hydraulic cylinder:

When using the servo hydraulic cylinder product, be sure to operate safely in accordance with the specification documents provided by the manufacturer, and pay attention to protecting the servo hydraulic cylinder block. If the servo hydraulic cylinder block is damaged, it will cause adverse consequences: ① The material debris extruded from the scratch groove will be embedded in the seal, which may cause new scratch area marks while damaging the working parts of the seal during operation. ② Deterioration of the surface roughness of the inner wall of the servo hydraulic cylinder, increase friction, easy to produce crawling phenomenon. ③ Increase the internal leakage of the servo hydraulic cylinder, so that the working efficiency of the servo hydraulic cylinder is reduced.

When the servo hydraulic cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the servo hydraulic cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil servo hydraulic cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical servo hydraulic cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the servo hydraulic cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

If the piston rod and servo hydraulic cylinder are stuck or the servo hydraulic cylinder is blocked, at this time, no matter how to operate, the servo hydraulic cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the servo hydraulic cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.

The viscosity of the working oil used in the servo hydraulic cylinder is 29~74mm2/S, and ISO VG46 anti-wear hydraulic oil is recommended. Working oil temperature within the range of -20~80. C. When the ambient temperature and service temperature are low, the oil with lower viscosity can be selected.

Answers to some questions about servo hydraulic cylinder:

What are the four cylinders of the truck crane?
The four cylinders of the truck crane generally refer to the telescopic cylinder of the boom (to adjust the length of the boom), the variable amplitude cylinder of the boom (to adjust the elevation Angle of the boom), the horizontal telescopic cylinder of the support leg and the vertical cylinder of the support leg.

What is the function of the Reza mounted master cylinder?
The role of the Resa-mounted master cylinder is to pump the concrete from the hopper to the delivery pipe and to provide sufficient concrete outlet pressure so that the concrete can reach the specified location.