stainless steel cylinder Sold to Singapore

This article mainly introduces:

Singapore hydraulic cylinder,stainless steel cylinder manufacturer,stainless steel cylinder

(Singapore stainless steel cylinder,produced by Hengyu Hydraulic Cylinder Factory）

stainless steel cylinder are widely used in Singapore，because of high work efficiency，excellent fatigue and impact resistance，no need for deceleration device.So our company has designed stainless steel cylinder for customers from Singapore.

Introduction to stainless steel cylinder:

The stainless steel cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the stainless steel cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the stainless steel cylinder wall due to the stiffness and the weight of the parts, causing scars.

When the stainless steel cylinder thrust is insufficient, check the hydraulic circuit for leaks. Including leakage of valves and hydraulic lines. The inspection method is to check and eliminate the leakage of the hydraulic connection line by manipulating the reversing valve. Also consider the relief valve. If the relief valve enters the dirt and jams the spool, so that the relief valve is normally open, the hydraulic oil will flow directly back to the tank through the relief valve bypass, resulting in no oil in the stainless steel cylinder. If the load is too large, although the regulating pressure of the relief valve has reached the maximum rating, the stainless steel cylinder still cannot get the thrust required for continuous action without action. If the regulating pressure is low, the pressure is insufficient to achieve the required vertebra force, which is manifested as insufficient thrust. Check and adjust the relief valve at this time.

The stainless steel cylinder is a hydraulic actuator that converts hydraulic energy into mechanical energy and does linear reciprocating motion (or swinging motion). It is simple in structure and reliable in operation. When it is used to achieve reciprocating movement, the deceleration device can be eliminated, and there is no transmission gap, and the movement is smooth, so it is widely used in various mechanical hydraulic systems. The output force of the stainless steel cylinder is proportional to the effective area of the piston and the pressure difference between the two sides; The stainless steel cylinder is basically composed of stainless steel cylinder and stainless steel cylinder head, piston and piston rod, sealing device, buffer device and exhaust device. Buffer device and exhaust device depending on the specific application, other devices are essential.

In the hydraulic system, sometimes the inner layer of the rubber hose is peeled off, so that the oil circuit is on and off, resulting in irregular stainless steel cylinder action. Troubleshooting method: Replace the rubber hose.

Answers to some questions about stainless steel cylinder:

Where's the hydraulic cylinder bleed valve?
There is a vent hole at the top of the cylinder next to the intake pipe. Generally, it can be used, and the air in the cylinder can be naturally drained after several moves.

The diameter of the cylinder is 180mm and the pressure is 14mpa. How many tons can the cylinder hold?
Calculate the area of the cylinder, 3.14*9*9=254.34 square centimeters, take the approximate number of engineering, 1 mpa pressure is about 10 kg per square centimeter, 14 mpa pressure is 140 kg per square centimeter, that is 254.34*140=35607.6 kilograms, it can be known that the cylinder can be about 35 tons in theory.