discharge door cylinder Sold to Ecuador

This article mainly introduces:

Ecuador hydraulic cylinder,discharge door cylinder manufacturer,discharge door cylinder

(Ecuador discharge door cylinder,produced by Hengyu Hydraulic Co., Ltd）

discharge door cylinder are widely used in Ecuador，because of no need for deceleration device，long service life，smooth movement.So our company has designed discharge door cylinder for customers from Ecuador.

Introduction to discharge door cylinder:

discharge door cylinder piston sealing is best to use Yx ring, polyurethane and polytetrafluoroethylene sealing material combination, can significantly improve the sealing performance: (I), reduce friction resistance, no crawling phenomenon; (ii) Have good dynamic and static sealing, wear resistance, long service life; (iii) The installation groove is simple, and the disassembly is simple.

The quality of the discharge door cylinder can not be ignored in the purchase of the discharge door cylinder. The discharge door cylinder is the main component of the discharge door cylinder, the single pillar for mining, the hydraulic support, the gun tube and other products, and its processing quality directly affects the life and reliability of the entire product. discharge door cylinder processing requirements are high, its internal surface roughness requirements are Ra0.4 ~ 0.8μm, the coaxiality, wear resistance requirements are strict. The basic feature of discharge door cylinder is deep hole processing, which has always troubled the processing personnel.

The internal leakage of the discharge door cylinder should be prevented when the discharge door cylinder is used. The internal leakage of discharge door cylinder includes the leakage caused by excessive wear of discharge door cylinder block seal, piston rod and seal cover seal and piston seal. The cause of sealing leakage between the piston rod and the seal cover is that the seal is wrinkled, squeezed, torn, worn, aging, deterioration, deformation, etc., and a new seal should be replaced at this time.

The discharge door cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the discharge door cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the discharge door cylinder wall due to the stiffness and the weight of the parts, causing scars.

Answers to some questions about discharge door cylinder:

How many tons is the oil cylinder 16mpa?
It depends on the cross-sectional area of the cylinder A(mm2)F=16mpa×A unit is (tons).

What is the difference between hydraulic cylinder self-adjusting buffer and adjustable buffer?
If it is the buffer device inside the cylinder, then there are 4 basic forms, cylindrical buffer device, conical buffer device, variable throttle and adjustable flow groove. The biggest difference between the first three and the latter is that the latter can be adjusted through the external thimble to change the buffer strength, the first three mainly rely on the buffer device and buffer groove form to achieve the buffer (among them, the first type of buffer strength will not change, and the buffer strength of the two and three forms of buffer devices can be gradually increased).