hydraulic hollow cylinder Sold to Nepal

This article mainly introduces:

Nepal hydraulic cylinder,hydraulic hollow cylinder manufacturer,hydraulic hollow cylinder

(Nepal hydraulic hollow cylinder,produced by Hengyu Hydraulic Co., Ltd）

hydraulic hollow cylinder are widely used in Nepal，because of long service life，smooth movement，high work efficiency.So our company has designed hydraulic hollow cylinder for customers from Nepal.

Introduction to hydraulic hollow cylinder:

The repair method of the hydraulic hollow cylinder: the repair of the hydraulic hollow cylinder must use brush plating. This is because this repair method can be carried out on site, and the repair effect is good. In this way, loading and transportation can be eliminated to shorten the repair time and improve work efficiency. In addition, the coating obtained by brush plating has good binding force and will not have obvious boundaries. Moreover, the repair surface has high hardness and good wear resistance.

When the hydraulic hollow cylinder is kept, do not pay attention to keeping the oil port open, which will produce the condition of accepting foreign bodies at all times, which is absolutely not allowed. Storage must be filled with anti-rust oil or working oil, and plug.

Most of the failure of the hydraulic hollow cylinder is because there is a foreign body in the hydraulic hollow cylinder into the failure of the hydraulic hollow cylinder, the most problematic is that it is difficult to determine when the foreign body is into the hydraulic hollow cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

The difference between the integral hydraulic hollow cylinder and the split hydraulic hollow cylinder: The integral hydraulic hollow cylinder and the split hydraulic hollow cylinder in the hydraulic hollow cylinder are two different hydraulic hollow cylinders, and they are very different. The whole hydraulic hollow cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split hydraulic hollow cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and hydraulic hollow cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

Answers to some questions about hydraulic hollow cylinder:

How is the hydraulic cylinder selected in the mechanical design manual?
First of all, it is necessary to meet your work needs, and the second is to meet the structural space of the cylinder and accessories. Three to consider the other parameters of the cylinder.

How to disassemble injection molding machine injection cylinder?
If it is not repaired for a long time, it is recommended to open both ends, comprehensively check the oil seal and piston ring inside, this is not much difficulty, pay attention to not install reverse when changing the oil seal, some piston rings are steel rings are rubber rings, and several interfaces of steel rings are not in the same position; Rubber ring pay attention not to install reverse; Be careful not to damage the oil seal when installing, otherwise it will soon leak oil.