trailer hydraulic cylinder Sold to Uruguay

This article mainly introduces:

Uruguay hydraulic cylinder,trailer hydraulic cylinder manufacturer,trailer hydraulic cylinder

(Uruguay trailer hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

trailer hydraulic cylinder are widely used in Uruguay，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed trailer hydraulic cylinder for customers from Uruguay.

Introduction to trailer hydraulic cylinder:

When the oil pressure of the trailer hydraulic cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

The trailer hydraulic cylinder should be avoided for a long time without use, if it is indeed idle for a long time for some reason, it should also be regularly turned on for empty operation, so that its parts can be fully lubricated, so as to avoid rust on the working surface and affect the normal work in the future. (If it cannot be turned on and run, a small amount of lubricating oil can be applied on its outer surface for protection) ' The use of the trailer hydraulic cylinder should pay attention to: the operation should be as far away from the trailer hydraulic cylinder as possible, to avoid falling objects, knocking, rubbing the trailer hydraulic cylinder coating. When cleaning the trailer hydraulic cylinder, only use soft materials (such as cotton) to wipe, and do not scratch high-hardness materials. Do not use the trailer hydraulic cylinder when the oil temperature exceeds 70 ° C.

The trailer hydraulic cylinder is mainly composed of body, piston, piston rod, trailer hydraulic cylinder head, trailer hydraulic cylinder bottom, piston rod head and related auxiliary devices. The piston divides the trailer hydraulic cylinder into two chambers, and moves reciprocally in the trailer hydraulic cylinder with the help of pressure oil. In order to improve its working effect, there is no sealing ring on the piston to eliminate internal leakage, where the piston rod passes through the trailer hydraulic cylinder head, due to the existence of the gap, it is easy to produce external leakage phenomenon, and the dust can enter the trailer hydraulic cylinder through the gap, so the sealing device and dust prevention reason are set. At the same time, in order to eliminate the influence of eccentric load on the work of the piston, all the trailer hydraulic cylinders must be provided with a considerable length of guide sleeve at the extended end of the piston rod. In addition, in the case of faster piston movement, the phenomenon of mechanical collision between the piston and the trailer hydraulic cylinder bottom and the trailer hydraulic cylinder head is serious, so the buffer deceleration should be set at both ends of the trailer hydraulic cylinder The working medium of the trailer hydraulic cylinder: because it works at room temperature, the ordinary oil-type hydraulic oil can be selected; trailer hydraulic cylinder sealing device: The use of Yx sealing ring, polyurethane (PU) and polytetrafluoroethylene (PTFE) materials combined to achieve a good sealing effect; Buffer mechanism of the trailer hydraulic cylinder: The buffer structure of the trailer hydraulic cylinder is to prevent the piston from colliding with the trailer hydraulic cylinder head at the end of the stroke.

The definition of the minimum starting pressure of the trailer hydraulic cylinder refers to the minimum working pressure of the trailer hydraulic cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the trailer hydraulic cylinder parts and the size of the sealing friction.

Answers to some questions about trailer hydraulic cylinder:

When the cylinder is tested, why can't the pressure be maintained with the balance valve?
Because the oil into the oil chamber through the hydraulic lock on the control oil circuit through the other side of the spool, the original valve is designed in this way. It locks the circuit after the oil supply circuit loses pressure, on the contrary, if you keep supplying pressure, it is always in the state of opening the other side of the one-way spool. So this valve can't be used in the test.

How does the hydraulic solenoid valve realize that the cylinder stops at any position?
Use an O-type medium function solenoid directional valve, or use a Y-type solenoid directional valve and a hydraulically controlled check valve.