pushing cylinder Sold to Angola

This article mainly introduces:

Angola hydraulic cylinder,pushing cylinder manufacturer,pushing cylinder

(Angola pushing cylinder,produced by Hengyu Group）

pushing cylinder are widely used in Angola，because of simple structure and reliable operation，excellent temperature resistance，no transmission clearance.So our company has designed pushing cylinder for customers from Angola.

Introduction to pushing cylinder:

The piston rod of the pushing cylinder has two kinds of solid rod and hollow rod, and one end of the hollow piston rod needs to be set aside for welding and heat treatment. The solid piston rod material is 35, 45 steel, and the hollow piston rod material is 35, 45 seamless steel pipe. After rough machining, the piston rod is conditioned to 229~285HB in India, and if necessary, the hardness is 45~55HRC after high-frequency quenching.

If the pushing cylinder piston rod is found to be worn, it can be brushed and plated first, then ground, and finally adjust the mating accuracy of the piston rod and the guide sleeve. At this time, the guide sleeve can be properly redrilled or the guide sleeve can be re-turned. When making the above repairs, remember to replace various rubber seals in time.

How the cavitation of the pushing cylinder is formed: With the gradual rise of pressure, the gas in the oil will become bubbles, when the pressure rises to a certain limit value, these bubbles will break under the action of high pressure, so that the high temperature and high pressure gas will quickly act on the surface of the parts, resulting in cavitation of the pushing cylinder, resulting in corrosive damage to the parts.

The pushing cylinder is not the same as the pushing cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the pushing cylinder can not be used as a high-power power component, but the pushing cylinder can be used as a relatively large power component, or the pushing cylinder system can be used.

Answers to some questions about pushing cylinder:

Hydraulic cylinder cost calculation method
1, Price cost accounting. Hydraulic cylinder price is composed of cost, profit and tax rate. Among them, the cost includes material cost, processing cost, assembly test fee, factory management fee (including the cost of designing drawings, etc., and the salary of management personnel is shared equally), brand promotion fee, utility and electricity equipment depreciation fee and other expenses. Cost of materials, including cylinder composition cylinder, piston rod, front and rear cover, guide, piston, seal, other accessories, etc. 2, Roughly estimate cylinder price = cylinder weight * parameters, parameters comprehensive consideration of various material costs and processing fees. The general market parameter is 20, the smaller and lighter the cylinder, the larger and heavier the cylinder, the smaller the parameter.

How to distinguish high pressure cylinder and low pressure cylinder?
There is no special definition of the cylinder, the so-called pressure classification refers to the pump low pressure (code L) container 0.1MPa ≤p < 1.6MPa; Medium pressure (code M) container 1.6MPa ≤p < 10.0MPa; High pressure (code H) vessel 10 MPa≤p < 100 MPa; Ultra-high pressure (code U) container p≥100MPa. (1MPa=9.8Kg)