servo hydraulic cylinder Sold to Algeria

This article mainly introduces:

Algeria hydraulic cylinder,servo hydraulic cylinder manufacturer,servo hydraulic cylinder

(Algeria servo hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory）

servo hydraulic cylinder are widely used in Algeria，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed servo hydraulic cylinder for customers from Algeria.

Introduction to servo hydraulic cylinder:

The servo hydraulic cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the servo hydraulic cylinder, bite. Elimination method: When installing the servo hydraulic cylinder, ensure that the axis position of the servo hydraulic cylinder is consistent with the direction of movement; Make the load borne by the servo hydraulic cylinder as far as possible through the servo hydraulic cylinder axis, to avoid the phenomenon of eccentricity.

When purchasing the servo hydraulic cylinder, try to clarify the following parameters of the servo hydraulic cylinder: A. servo hydraulic cylinder diameter, rod diameter, stroke; B. Working pressure or servo hydraulic cylinder load; C. Working environment temperature; D. Working medium; E. Operating speed; F. Other parameters, such as connection form, mounting size, etc. In this way, the right servo hydraulic cylinder type can be found accurately and quickly.

The internal leakage of the servo hydraulic cylinder is an important indicator to measure the quality of the servo hydraulic cylinder: the internal leakage of the servo hydraulic cylinder will reduce the volumetric efficiency, increase the temperature rise of the oil, affect the positioning accuracy of the servo hydraulic cylinder, so that the servo hydraulic cylinder can not accurately and stably stop in a certain position of the servo hydraulic cylinder, so it is one of the main indicators of the servo hydraulic cylinder.

When the servo hydraulic cylinder needs to be disassembled for maintenance due to leakage and other faults, the piston should be moved to the bottom position of the servo hydraulic cylinder, and hard beating and sudden drop are strictly prohibited during disassembly.

Answers to some questions about servo hydraulic cylinder:

Why manual forklift oil cylinder can not lift up?
Manual hydraulic forklift truck often can not be pressed up, there are several reasons: for manual hydraulic truck: 1) There is no hydraulic oil 2) the purity of the oil is not enough 3) the adjusting bolt is too close or the adjusting screw is too tight, so that the valve is always open, 4) there is an air in the hydraulic cylinder. Method: 1) Refueling 2) Oil change 3) air discharge. For manual hydraulic stacker, also called manual lift car 1) Less than the amount of oil 2) impurities in the hydraulic oil, so that the check valve can not be closed. Method 1) Add enough hydraulic oil 2) Remove the cylinder, screw off the bottom plate, remove the impurities in the bottom plate.

In a hydraulic system, a hydraulic pump has many hydraulic cylinders and hydraulic motors, and these executive components do not coordinate their actions with each other.
A load-sensitive variable pump can be used if these components sometimes need to work simultaneously and the power required is large. The required flow is distributed by the multi-way reversing valve, and the required flow and pressure changes are automatically adjusted by the hydraulic pump. Pressure reducing valves can be used for particularly low pressure circuits. Because you execute more components, the use of quantitative pump will cause a waste of energy, the system heat is large, not suitable.