steel mill cylinder Sold to Austria

This article mainly introduces:

Austria hydraulic cylinder,steel mill cylinder manufacturer,steel mill cylinder

(Austria steel mill cylinder,produced by Hengyu Hydraulic Cylinder Factory）

steel mill cylinder are widely used in Austria，because of smooth movement，high work efficiency，excellent fatigue and impact resistance.So our company has designed steel mill cylinder for customers from Austria.

Introduction to steel mill cylinder:

The steel mill cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the steel mill cylinder, bite. Elimination method: When installing the steel mill cylinder, ensure that the axis position of the steel mill cylinder is consistent with the direction of movement; Make the load borne by the steel mill cylinder as far as possible through the steel mill cylinder axis, to avoid the phenomenon of eccentricity.

The main role of the steel mill cylinder: the steel mill cylinder is an executive element in the hydraulic transmission system, which is an energy conversion device that converts hydraulic energy into mechanical energy. The hydraulic motor realizes continuous rotary motion, while the steel mill cylinder realizes reciprocating motion. The structure of the steel mill cylinder has three categories: piston steel mill cylinder, plunger steel mill cylinder, swing steel mill cylinder, piston steel mill cylinder and plunger steel mill cylinder to achieve reciprocating linear motion, output speed and thrust, swing steel mill cylinder to achieve reciprocating swing, output angular speed (speed) and torque. In addition to the single use of the steel mill cylinder, two or more can be combined or used in combination with other mechanisms. To fulfill a special function. The steel mill cylinder has simple structure and reliable operation, and has been widely used in the hydraulic system of machine tools.

The quality of the steel mill cylinder can not be ignored in the purchase of the steel mill cylinder. The steel mill cylinder is the main component of the steel mill cylinder, the single pillar for mining, the hydraulic support, the gun tube and other products, and its processing quality directly affects the life and reliability of the entire product. steel mill cylinder processing requirements are high, its internal surface roughness requirements are Ra0.4 ~ 0.8μm, the coaxiality, wear resistance requirements are strict. The basic feature of steel mill cylinder is deep hole processing, which has always troubled the processing personnel.

When the steel mill cylinder is installed on the main engine, the oil port piping part and the guide sleeve should be checked for oil leakage in the running test, and the earring and the middle hinge shaft bearing should be refueled.

Answers to some questions about steel mill cylinder:

Why the cylinder cannot operate normally after the explosion-proof valve is installed?
The pipeline explosion-proof valve is specially designed to prevent pipeline damage and free fall of the cylinder, so there must be back pressure to open. If there is no oil return pressure, or the oil return pressure is too small, and can not adjust the oil return pressure, such a system with explosion-proof valves is more troublesome, it is recommended to add a one-way throttle valve between the cylinder and the tank to establish back pressure. If you understand the explosion-proof valve, you can also try to adjust the opening of the valve (that is, the flow of the regulating valve), and adjust the opening to help the valve to open.

How does the cylinder work?
Hydraulic transmission principle: oil as the working medium, through the change of the sealing volume to transfer movement, through the internal pressure of the oil to transfer power. 1. The power part - converts the mechanical energy of the prime mover into the pressure energy of the oil (hydraulic energy). For example: hydraulic pump. 2, the executive part - the hydraulic pump input oil pressure energy into the mechanical energy to drive the working mechanism. For example: hydraulic cylinder, hydraulic motor. 3, the control part - used to control and adjust the oil pressure, flow and flow direction. For example: pressure control valve, flow control valve and direction control valve. 4, the auxiliary part - the first three parts are connected together to form a system, which plays the role of oil storage, filtration, measurement and sealing.