single rack cylinder Sold to Sri Lanka

This article mainly introduces:

Sri Lanka hydraulic cylinder,single rack cylinder manufacturer,single rack cylinder

(Sri Lanka single rack cylinder,produced by Hengyu Hydraulic Cylinder Factory）

single rack cylinder are widely used in Sri Lanka，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed single rack cylinder for customers from Sri Lanka.

Introduction to single rack cylinder:

Before the single rack cylinder is removed, the system should be unloaded, the loop pressure is zero, the oil source should be cut off, and the oil port should be blocked after the oil port distribution pipe is loosened.

single rack cylinder can not drive the load troubleshooting: oil pressure is too low. single rack cylinder selection specifications are too small. Leakage in single rack cylinder or associated hydraulic system element.

Before purchasing the single rack cylinder, it is necessary to master the original information and design basis, mainly including: the use and working conditions of the machine; The structural characteristics, load conditions, stroke size and operation requirements of the working mechanism; The selected working pressure and flow of the hydraulic system; The reality of materials, fittings and processes; Relevant national standards and technical specifications, etc.

In the case of serious wear on the inner surface of the single rack cylinder, or when there is a deep longitudinal tensile mark, it should be mapped according to the physical object and re-produced by the professional manufacturer according to the single rack cylinder manufacturing process for replacement. The single rack cylinder can also be repaired with TS311 antiwear repair agent. TS311 anti-wear repair agent is mainly used for the repair of worn and slipped metal parts.

Answers to some questions about single rack cylinder:

How many kinds of cylinder seal repair kit are there?
Very much, a wide variety of imported and domestic, J type, UHS, DHS, O-ring, Sterseal, etc., as well as support bars, materials are different, according to the size of the pressure selection is different, the appearance of the structure is different, the size is a variety, maintenance is generally selected according to the needs of the cylinder.

How many tons is the oil cylinder 16mpa?
It depends on the cross-sectional area of the cylinder A(mm2)F=16mpa×A unit is (tons).