spring return cylinder Sold to Holland

This article mainly introduces:

Holland hydraulic cylinder,spring return cylinder manufacturer,spring return cylinder

(Holland spring return cylinder,produced by Hebei Hengyu company）

spring return cylinder are widely used in Holland，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed spring return cylinder for customers from Holland.

Introduction to spring return cylinder:

The quality of the spring return cylinder can not be ignored in the purchase of the spring return cylinder. The spring return cylinder is the main component of the spring return cylinder, the single pillar for mining, the hydraulic support, the gun tube and other products, and its processing quality directly affects the life and reliability of the entire product. spring return cylinder processing requirements are high, its internal surface roughness requirements are Ra0.4 ~ 0.8μm, the coaxiality, wear resistance requirements are strict. The basic feature of spring return cylinder is deep hole processing, which has always troubled the processing personnel.

The spring return cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

spring return cylinder abnormal sound, hysteresis phenomenon cause and elimination method: the piston rod is extended with abnormal sound and hysteresis, if the spring return cylinder is placed for a period of time, the spring return cylinder may enter the air, and the movement can be normal after dozens of repeated movements. If it still cannot be eliminated, check whether the load is aligned with the axis of the piston rod; Retracted piston rod installation helps to align the load with the piston rod. If the flow is unstable, it will also lead to abnormal movement of the piston rod. Check the relevant components of the hydraulic system.

When the hydraulic oil is not pumped into the spring return cylinder, it is necessary to check whether the tubing, oil circuit, especially the hose joint has been blocked, and the relevant oil circuit from the spring return cylinder to the pump should be checked in turn and blocked; Check whether the seal between the taper valve and the seat of the relief valve is good; Check whether the solenoid valve spring is damaged or whether the solenoid coil is burned out; Whether the oil circuit is switched is insensitive.

Answers to some questions about spring return cylinder:

Need a hydraulic cylinder, vertical upward 10 seconds to lift 20 tons of weight up 2 meters, how large cylinder and rod, how much pressure to use the plunger pump and how big?
The first thing to determine the system pressure, let's say 25 mpa, can take into account cost and performance. 1 Cylinder area 20000/250=80 square cm cylinder diameter (80/3.14) squared x2=200 mm 2 cylinder volume 80x200=16000 ml =16 L 3 Required pump flow 16x60/10=96 L/min 4 Power 96x25/55=43 kW 45 kW motor is available.

Where is the tension cylinder used in the excavator?
Get off the inside of the frame, behind the guide wheel (steering wheel, guide wheel). Disassemble the track and take the guide wheel out to see the tensioning cylinder (track spring).