single rack cylinder Sold to Hungary

This article mainly introduces:

Hungary hydraulic cylinder,single rack cylinder manufacturer,single rack cylinder

(Hungary single rack cylinder,produced by Hengyu Hydraulic Cylinder Factory）

single rack cylinder are widely used in Hungary，because of no need for deceleration device，long service life，smooth movement.So our company has designed single rack cylinder for customers from Hungary.

Introduction to single rack cylinder:

When the single rack cylinder is customized, if there are high requirements for the quality of the single rack cylinder, it is best to use rolling processing, because the surface layer has surface residual compressive stress, which helps to close the surface of the small crack, preventing the expansion of erosion. Thus, the corrosion resistance of the surface can be improved, and the fatigue crack can be delayed or expanded, and the fatigue strength of the single rack cylinder can be improved. By rolling forming, a cold working hardening layer is formed on the rolling surface, which reduces the elastic and plastic deformation of the contact surface of the grinding pair, thereby improving the wear resistance of the inner wall of the single rack cylinder and avoiding the burn caused by grinding. After rolling, the reduction of surface roughness value can improve the matching property.

Before the single rack cylinder is removed, the system should be unloaded, the loop pressure is zero, the oil source should be cut off, and the oil port should be blocked after the oil port distribution pipe is loosened.

The single rack cylinder can not be used as grounding electrode to avoid electric damage to the piston rod.

The single rack cylinder is not the same as the single rack cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the single rack cylinder can not be used as a high-power power component, but the single rack cylinder can be used as a relatively large power component, or the single rack cylinder system can be used.

Answers to some questions about single rack cylinder:

Cylinder pressure calculation formula
The pressure of the cylinder at work is determined by the load, and the pressure of the physical force is equal to the force divided by the area of action (that is, P=F/S). If you want to calculate the output force of the cylinder, you can calculate it according to the formula: Set the radius of the piston (that is, the cylinder) is R (unit mm) the radius of the piston rod is r (unit mm) the working pressure P (unit MPa) the thrust of the cylinder F push =3.14*R*R*P (unit N) The pulling force of the cylinder F pull =3.14* (R*R-r* R) *P (unit N).

Why are two cylinders not balanced with the balance valve?
Balancing valve is only suitable for occasions with low synchronous accuracy requirements, and proportional valves are recommended for occasions with high precision requirements.