steering cylinder Sold to Belgium

This article mainly introduces:

Belgium hydraulic cylinder,steering cylinder manufacturer,steering cylinder

(Belgium steering cylinder,produced by Hengyu Hydraulic Co., Ltd）

steering cylinder are widely used in Belgium，because of no need for deceleration device，smooth movement，excellent temperature resistance.So our company has designed steering cylinder for customers from Belgium.

Introduction to steering cylinder:

The oil steering cylinder is a part of the hydraulic system, in the hydraulic system, to reasonably design the heat dissipation system, to prevent the oil temperature is too high is the key to keep the hydraulic oil temperature normal. The temperature of the system should be kept in a suitable range to reduce the energy released when the bubble bursts. While not affecting the normal circulation of the coolant, a certain amount of anti-corrosion additives can be appropriately added to inhibit rust. When operating the hydraulic system, we should strive to be stable, not too fast, too strong, and try to reduce the impact of hydraulic oil on hydraulic components.

steering cylinder buffer valve inspection and maintenance: For the valve buffer steering cylinder, the focus should be on checking the wear of the buffer valve spool and seat. Once it is found that the amount of wear increases and the seal fails, it should be replaced. It can also be repaired by using abrasive spool and seat matching grinding method.

The difference between the integral steering cylinder and the split steering cylinder: The integral steering cylinder and the split steering cylinder in the steering cylinder are two different steering cylinders, and they are very different. The whole steering cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split steering cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and steering cylinder damage. Therefore, it is obvious that the answer to this question is for difference.

steering cylinder to reasonable use of hydraulic oil: strict hydraulic oil selection off. Hydraulic oil is selected in strict accordance with oil standards. The selection of good quality hydraulic oil can effectively prevent bubbles in the working process of the hydraulic system. When choosing the oil, it should be selected according to the lowest temperature in different regions, and fill the hydraulic oil according to the dipstick standard, and at the same time, it should also keep the hydraulic system clean (when filling the hydraulic oil, it should prevent the water and other impurities into it), and often check the oil quality, oil level and oil color of the hydraulic oil. If blisters and bubbles are found in the hydraulic oil. When the oil becomes milky white, the source of the air in the oil should be carefully found and eliminated in time.

Answers to some questions about steering cylinder:

The pressure gauge of the hydraulic station reaches 20MPa. How many tons of weight can the hydraulic cylinder lift? How to convert?
20Mpa=200kg/cm^2 The weight of the cylinder with a cross-sectional area of 1 square centimeter can be lifted is 200kg, so F=200X3.14X (125/2) ^2 =24531kg =24.5 tons.

How to calculate the hydraulic cylinder pressure, how much pressure can put up how much weight?
There is a formula for air pressure, hydraulic pressure, water pressure: F=P×S type: f-cylinder or hydraulic cylinder output, unit is Newton (N) P- pressure, unit is Mpa S- effective area, unit is square millimeter (mm2), note: is the effective area, in the hydraulic cylinder to subtract the cross-sectional area of the piston rod.