synchronous hydraulic cylinder Sold to Belgium

This article mainly introduces:

Belgium hydraulic cylinder,synchronous hydraulic cylinder manufacturer,synchronous hydraulic cylinder

(Belgium synchronous hydraulic cylinder,produced by Hebei Hengyu company）

synchronous hydraulic cylinder are widely used in Belgium，because of excellent temperature resistance，no transmission clearance，powerful torque.So our company has designed synchronous hydraulic cylinder for customers from Belgium.

Introduction to synchronous hydraulic cylinder:

synchronous hydraulic cylinder piston rod material introduction: In general, we use 45 steel to produce synchronous hydraulic cylinder piston rod. It has a large impact force when it is used, and some good performance steel are also used in the heavy load transmission. In order to have enough work intensity when using, and can ensure normal use, this is still more critical to have a detailed understanding of the material.

synchronous hydraulic cylinder can not drive the load troubleshooting: oil pressure is too low. synchronous hydraulic cylinder selection specifications are too small. Leakage in synchronous hydraulic cylinder or associated hydraulic system element.

At the rated pressure, the thrust of the synchronous hydraulic cylinder is determined by what factors: at the rated pressure of the oil pump, the work done by the synchronous hydraulic cylinder is related to the diameter of the synchronous hydraulic cylinder, but not to the stroke of the synchronous hydraulic cylinder. Moreover, the larger the synchronous hydraulic cylinder diameter, the larger the area, and the greater the pressure obtained. To this point, we should have a correct understanding and clear understanding, so as to avoid problems in the use of the synchronous hydraulic cylinder.

synchronous hydraulic cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the synchronous hydraulic cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the synchronous hydraulic cylinder. c. The synchronous hydraulic cylinder seal is extruded, if the O-ring is obviously extruded at the synchronous hydraulic cylinder seal, replace the synchronous hydraulic cylinder seal.

Answers to some questions about synchronous hydraulic cylinder:

How to design the guide sleeve of cylinder diameter 400?
The purpose of the guide sleeve is to guide and seal. Therefore, it is necessary to look at the speed of the piston rod, working pressure and radial force. High speed, medium pressure, no (or very little) radial force, with a Steseal. Low speed and heavy load, medium radial force, combined seal. High speed and heavy load, large radial force, sealed with DU sleeve + copper ring + combination. The combination seal must have a lubricating oil passage, and a seal must be added to the outside of the oil passage.

How to distinguish loader boom and forearm hydraulic cylinder? Is it the upper arm or the lower arm?
The one in the middle that can flip the bucket is the small arm cylinder you say, and the one that lifts the brackets (big arms) on both sides is the big arm cylinder.